Tianjin Reliance Steel Pipe Industry & Trade Co., Ltd. was officially founded in 2004, and is located in Caigongzhuang Industrial Area in Jinghai County, Tianjin, China. We are a joint-stock enterprise, with 3 branch plants.
Our main products are:
Welded Pipes, Square & Rectangular Hollow Section Tubes
Galvanized Steel Welded Pipe and Pre-galvanized Steel Pipes.
Address:Hi-Tech information square, NanKai district of Tianjin.
►SUBSCRIBE for new videos every Monday and Friday: https://goo.gl/FRdNss
When we talk about 6G pipe welding, we are talking about welding two pieces of pipe (of any size or material) together in a fixed 45 degree angle. Being able to weld in the 6G position will qualify you to weld in any other position. It will not, however qualify you to weld any material in that position. In this video, we are going to show you how to weld 6 inch Carbon Steel Pipe in the 6G position to help you pass a test or get a job.
I have a question: When I am TIG welding roots, on a 6″ sch 40, sometimes i stop the lay wire process and keyhole, and sometimes it gets really big, do u know why this happens?
If the wire is not in the leading edge of the pool acting as a “sink,” then the root filler metal can fall to the inside if you keep the welding amperage the same. This can lead to undesirable build up, aka, “bumps” or “grapes”, and can cause the root pass reinforcement to exceed allowable limits. This will usually happen in the vertical and top sections of a 5G or 6G weld. The very bottom section (overhead) of a 5G or 6G weld usually just lays flat or sucks back to a concave profile.
If you are welding with remote amperage; simply reduce the amperage when the wire leaves the pool, re-position wire to the leading edge of the weld, and increase the amperage to the desirable range and continue welding.
If you are not using remote amperage controls; move the arc up on the bevel and increase arc length to reduce amperage, and re-position the filler wire to the leading edge of the pool before continuing.
I have witnessed many welds made with the keyhole or drip type transfer of filler metal that were successful. I have used this technique on stainless and nickel based alloys with the desired results. However, I find it to be much slower, especially on carbon steel.
► MIG Monday: New Videos every Monday!
► TIG Time: New Videos every Friday!
EQUIPMENT WE USE:
► ArcOne Helmets: www.arc1weldsafe.com
► CK Worldwide TIG Accessories – www.ckworldwide.com
► West Chester Protective Gear – www.westchestergear.com
► Tab and Slot Welding Tables: www.tabandslot.com
► Philips Welding Lenses (for Filming): www.phillips-safety.com/
► ESAB Power Sources: www.ESAB.com
JOIN US ON:
► FACEBOOK : https://www.facebook.com/welddotcom
► INSTAGRAM : https://www.instagram.com/welddotcom/
► FORUM : https://www.instagram.com/welddotcom/
► TWITTER : https://twitter.com/welddotcom
► STORE : https://weld.com/index.php/shop-weld-com